Fault Interpretation Based on Similarity and Curvature Attributes in F3 Netherlands

Interpretasi Sesar Berdasarkan Atribut Similarity dan Curvature di Lapangan F3 Netherlands

Authors

  • Nadea Arie Saragih Program Studi Teknik Geofisika, Fakultas Sains dan Teknologi , Universitas Jambi, Jl. Jambi – Muara Bulian Km. 15 36361, Jambi
  • Faizar Farid Program Studi Kimia, Fakultas Sains dan Teknologi , Universitas Jambi, Jl. Jambi – Muara Bulian Km. 15 36361, Jambi
  • Juventa Juventa Program Studi Teknik Geofisika, Fakultas Sains dan Teknologi , Universitas Jambi, Jl. Jambi – Muara Bulian Km. 15 36361, Jambi

DOI:

https://doi.org/10.20956/geocelebes.v6i1.14080

Keywords:

Curvature, F3 Netherlands, Similarity, Southern Basin North Sea

Abstract

F3 Southern North Sea Netherlands Basin field is an oil and gas field that has a complex fault structure and stratigraphy due to compressional tectonic movements during the Late Cretaceous and Tertiary eras. Information on the presence of faults can act as a trap or migration which then greatly affects oil and gas production and the injection process. A seismic attribute analysis of similarity and curvature was used to interpret the presence of fault structures to obtain information on the presence of subsurface faults in the F3 Netherlands field. The interpretation of the similarity attribute calculation results shows that the faults are marked with a minimum similarity value of 0.77, 0.68, and 0.66 at the time slices Z = 400ms, 1700ms, and 1800ms. The maximum value of most post-positive curvature represents the presence of an ascending fault block and the maximum value of the most negative curvature represents the presence of a descending fault block at the same time incision. Based on the similarity and curvature attribute calculations, it can be interpreted that the major faults in Top Zechstein to Upper Pliocene and the presence of successive faults on Top Zechstein to Base Lower Cretaceous are faults due to the formation of the Zechstein salt dome intrusion

References

Alfredo, A. and Sulistyanto, D. 2015. Analisis Sifat Patahan (Sealing-leaking) Berdasarkan Data Tekanan, Decline Curve, dan Connectivity Injection pada Lapangan Dima. In: Seminar Nasional Cendekiawan 2015, Jakarta, Indonesia, pp.116-125. https://media.neliti.com/media/publications/171439-ID-analisis-sifat-patahan-sealing-leaking-b.pdf

Brown, A.R. 2004. Interpretation of Three-Dimensional Seismic Data (6th Edition). Memoir 42. American Association of Petroleum geologists, Tulsa, OK, USA.

Cameron, N. and Ziegler, T. 1997. Probing the lower limits of a fairway: further pre-Permian potential in the southern North Sea. Geological Society (London) Special Publication 123: 123–141. https://doi.org/10.1144/GSL.SP.1997.123.01.08

de Jager, J. and Geluk, M.C. 2007. Petroleum Geology. Geology of the Netherlands. Royal Netherlands Academy of Arts and Sciences, Amsterdam, 241, p.264.

Kumar, P.C. and Sain, K. 2018. Attribute amalgamation-aiding interpretation of faults from seismic data: An example from Waitara 3D prospect in Taranaki basin off New Zealand. Journal of Applied Geophysics. 159, pp. 52-68. https://doi.org/10.1016/j.jappgeo.2018.07.023

Laban, C. 1995. The Pleistocene glaciations in the Dutch sector of the Southern North Sea. A synthesis of sedimentary and seismic data. Ph.D. thesis, University of Amsterdam. https://www.researchgate.net/publication/241874061_The_Pleistocene_glaciations_in_the_Dutch_sector_of_the_North_Sea_A_synthesis_of_sedimentary_and_seismic_data

Marcus, H. 1932. Die Theorie elastischer Gewebe und ihre Anwendung auf die Berechnung biegsamer Platten unter besonderer Berücksichtigung der trägerlosen Pilzdecken. Berlin: Springer.

Nielsen, N.J. 1920. Bestemmelse af spændinger i plader ved anvendelse af differensligninger. Copenhagen: Gad.

Overeem, I., Weltje, G.J., Bishop-Kay, C. and Kroonenberg, S.B. 2001. The Late Cenozoic Eridanos delta system in the Southern Southern North Sea Basin: a climate signal in sediment supply. Basin Research. 13, pp.293–312. https://doi.org/10.1046/j.1365-2117.2001.00151.x

Sørensen, J.C., Gregersen, U., Breiner, M. and Michelsen, O. 1997. High-frequency sequence stratigraphy of Upper Cenozoic deposits in the central and southeastern Southern North Sea areas. Marine and Petroleum Geology. 14(2), pp.99-123. https://doi.org/10.1016/S0264-8172(96)00052-9

Schroot, B.M. and Haan, H.B. 2003. Intra-Carboniferous tectonics of the Southern Southern North Sea Basin. In: Fifteenth International Congress on Carboniferous and Permian Stratigraphy, August 10-16 Utrecht, abstract no. 319, p. 479-480.

Tingdahl, K. M., 2003. Improving seismic chimney detection using directional attributes, in: Nikarvesh, M., Aminzadeh, F., Zadeh, L.A, (eds.) Soft Computing and Intelligent Data Analysis in Oil Exploration, Developments in Petroleum science. 51, pp. 157-173. https://doi.org/10.1016/S0376-7361(03)80013-4

Tingdahl, K. and de Rooij, M. 2005. Semi-automatic detection of faults in 3D seismic data. Geophysical Prospecting. 53, pp. 533-542. https://doi.org/10.1111/j.1365-2478.2005.00489.x

Downloads

Published

2022-04-08

How to Cite

Saragih, N. A., Farid, F., & Juventa, J. (2022). Fault Interpretation Based on Similarity and Curvature Attributes in F3 Netherlands: Interpretasi Sesar Berdasarkan Atribut Similarity dan Curvature di Lapangan F3 Netherlands . JURNAL GEOCELEBES, 6(1), 1–11. https://doi.org/10.20956/geocelebes.v6i1.14080

Issue

Vol. 6 No. 1: April 2022

Section

Articles

License

Authors who publish with this journal agree to the following terms:

  1. Authors retain copyright and grant the journal right of first publication with the work simultaneously licensed under a Creative Commons Attribution License that allows others to share the work with an acknowledgement of the work's authorship and initial publication in this journal.
  2. Authors are able to enter into separate, additional contractual arrangements for the non-exclusive distribution of the journal's published version of the work (e.g., post it to an institutional repository or publish it in a book), with an acknowledgement of its initial publication in this journal.
  3. Authors are permitted and encouraged to post their work online (e.g., in institutional repositories or on their website) prior to and during the submission process, as it can lead to productive exchanges, as well as earlier and greater citation of published work (See The Effect of Open Access).