Comparison of Window Scan and Digital Outcrop Model Approaches for Fracture Characterisation Along the Lampung–Panjang Fault Zone
DOI:
https://doi.org/10.70561/geocelebes.v10i2.52858Kata Kunci:
Fracture Characterisation, Digital Outcrop Model, Photogrammetry, Structural GeologyAbstrak
Fracture characterisation is an important component of structural geological studies because fracture orientation and distribution provide insights into tectonic deformation and rock mass behaviour. However, conventional field-based fracture measurements are often constrained by limited outcrop accessibility and observation coverage. This study evaluated the applicability of Digital Outcrop Models generated from unmanned aerial vehicle photogrammetry for fracture characterisation within crystalline rocks along the Lampung–Panjang Fault zone, southern Sumatra, Indonesia. Fracture data were collected from four outcrops using both the window scan method and digital measurements derived from georeferenced three-dimensional outcrop models. The aerial imagery was processed to generate orthomosaics and digital outcrop models, from which fracture traces were identified and analyzed. A total of 124 fractures were measured using the window scan method, whereas 319 fractures were extracted from the digital outcrop models. Results showed that both approaches consistently identified dominant northwest–southeast and northeast–southwest fracture orientations across the study area. Although differences were observed in dip distributions and contour dispersion, the digital outcrop models preserved the principal fracture patterns recognized in the field while providing a larger dataset and broader spatial coverage. These findings demonstrated that digital outcrop models can reliably represent fracture geometries and serve as an effective alternative to conventional measurements, particularly in inaccessible outcrops. The study highlights the potential of drone-based photogrammetry to improve the efficiency and completeness of structural geological mapping and fracture characterisation.
Referensi
Andrews, B. J., Roberts, J. J., Shipton, Z. K., Bigi, S., Tartarello, M. C., & Johnson, G. (2019). How do we see fractures? Quantifying subjective bias in fracture data collection. Solid Earth, 10, 487–516. https://doi.org/10.5194/se-10-487-2019
Assali, P., Grussenmeyer, P., Villemin, T., Pollet, N., & Viguier, F. (2014). Surveying and modeling of rock discontinuities by terrestrial laser scanning and photogrammetry: Semi-automatic approaches for linear outcrop inspection. Journal of Structural Geology, 66, 102–114. https://doi.org/10.1016/j.jsg.2014.05.014
Bemis, S. P., Micklethwaite, S., Turner, D., James, M. R., Akciz, S., Thiele, S. T., & Bangash, H. A. (2014). Ground-based and UAV-Based photogrammetry: A multi-scale, high-resolution mapping tool for structural geology and paleoseismology. Journal of Structural Geology, 69, 163–178. https://doi.org/10.1016/j.jsg.2014.10.007
Bistacchi, A., Mittempergher, S., Martinelli, M., & Storti, F. (2020). On a new robust workflow for the statistical and spatial analysis of fracture data collected with scanlines (or the importance of stationarity). Solid Earth, 11, 2535–2547. https://doi.org/10.5194/se-11-2535-2020
Burnham, B. S., Bond, C. E., Flaig, P. P., van der Kolk, D. A., & Hodgetts, D. (2022). Outcrop conservation: Promoting accessibility, inclusivity, and reproducibility through digital preservation. The Sedimentary Record, 20(1), 5–14. https://doi.org/10.2110/sedred.2022.1.2
Caravaca, G., Le Mouélic, S., Mangold, N., L’Haridon, J., Le Deit, L., & Massé, M. (2020). 3D digital outcrop model reconstruction of the Kimberley outcrop (Gale crater, Mars) and its integration into Virtual Reality for simulated geological analysis. Planetary and Space Science, 182, 104808. https://doi.org/10.1016/j.pss.2019.104808
Fardana, Y. C., Setianto, A., & Husein, S. (2024). Digital Fracture Porosity Measurement using Digital Outcrop Modelling (DOM). IOP Conference Series: Earth and Environmental Science, 1373, 012055. https://doi.org/10.1088/1755-1315/1373/1/012055
Farny, N. J. (2017). Comparing Rock Discontinuity Measurements Using Geological Compass, Smartphone Application, and Laser Scanning Methods. Environmental & Engineering GeoScience, 23(2), 97–112. https://doi.org/10.2113/gseegeosci.23.2.97
Haerudin, N., Darmawan, I. G. B., Mulyasari, R., Karyanto, K., & Persada, C. (2026). Identifying The Seismic Risk Zoning Along The Lampung-Panjang Fault and Surroundings based on A Comprehensive Gravity and Microtremor Analysis. Earth and Planetary Science, 3, 3–14. https://doi.org/10.21303/2461-4262.2026.003948
Koesmawardani, W. T., Burhannudinnur, M., & Maulana, G. F. (2020). Identification of Natural Fractures Using Digital Outcrop Model (DOM) and Filedwork Data at Granitic Basement Rocks Muaro Silokek, West Sumatra. Technology Reports of Kansai University, 62(03), 645–654. https://www.researchgate.net/publication/344460189_Identification_of_Natural_Fractures_Using_Digital_Outcrop_Model_DOM_and_Filedwork_Data_at_Granitic_Basement_Rocks_Muaro_Silokek_West_Sumatra
Koesmawardani, W. T., Sapiie, B., & Rudyawan, A. (2021). Fracture characterization with fieldwork data and its implication for basement fracture reservoir at Muaro Silokek Granitic Outcrops. IOP Conference Series: Materials Science and Engineering, 1098(6), 062019. https://doi.org/10.1088/1757-899x/1098/6/062019
Liang, B., Liu, Y., Shao, Y., Wang, Q., Zhang, N., & Li, S. (2022). 3D quantitative characterization of fractures and cavities in Digital Outcrop texture model based on Lidar. Energies, 15(5), 1627. https://doi.org/10.3390/en15051627
Liu, Y., Chen, J., Tan, C., Zhan, J., Song, S., Xu, W., Yan, J., Zhang, Y., Zhao, M., & Wang, Q. (2022). Intelligent scanning for optimal rock discontinuity sets considering multiple parameters based on manifold learning combined with UAV photogrammetry. Engineering Geology, 309, 106851. https://doi.org/10.1016/j.enggeo.2022.106851
Mangga, S. A., Amirudin, A., Suwarti, T., Gafoer, S., & Sidarto, S. (2010). Peta Geologi Lembar Tanjungkarang, Sumatera. Pusat Survei Geologi. https://geologi.esdm.go.id/geomap/pages/preview/peta-geologi-lembar-tanjungkarang-sumatera
Martinelli, M., Bistacchi, A., Mittempergher, S., Bonneau, F., Balsamo, F., Caumon, G., & Meda, M. (2020). Damage Zone Characterization combining scan-line and scan-area analysis on a km-scale Digital Outcrop Model: The Qala Fault (Gozo). Journal of Structural Geology, 140, 104144. https://doi.org/10.1016/j.jsg.2020.104144
Menegoni, N., Giordan, D., Inama, R., & Perotti, C. (2023). DICE : An open-source MATLAB application for quanti fi cation and parametrization of digital outcrop model-based fracture datasets. Journal of Rock Mechanics and Geotechnical Engineering, 15(5), 1090–1110. https://doi.org/10.1016/j.jrmge.2022.09.011
Nesbit, P. R., Durkin, P. R., Hugenholtz, C. H., Hubbard, S. M., & Kucharczyk, M. (2018). 3-D stratigraphic mapping using a digital outcrop model derived from UAV images and structure-from-motion photogrammetry. Geosphere, 14(6), 2469–2486. https://doi.org/10.1130/GES01688.1
Osterman, F. (2017). Comparison of Photogrammetry Interpretation with Physical Structural Field Measurements. Uppsala University. https://uu.diva-portal.org/smash/record.jsf?pid=diva2:1111024
Panara, Y., Chandra, V., Finkbeiner, T., Petrovic, A., Zühlke, R., Khanna, P., & Vahrenkamp, V. (2023). Fracture intensity and associated variability: A new methodology for 3D digital outcrop model analysis of carbonate reservoirs. Marine and Petroleum Geology, 158, 106532. https://doi.org/10.1016/j.marpetgeo.2023.106532
Panara, Y., Menegoni, N., Finkbeiner, T., Zühlke, R., & Vahrenkamp, V. (2024). High-resolution analysis of 3D fracture networks from Digital Outcrop Models, correlation to plate-tectonic events and calibration of subsurface models (Jurassic, Arabian Plate). Marine and Petroleum Geology, 167, 106998. https://doi.org/10.1016/j.marpetgeo.2024.106998
Perozzo, M., Menegoni, N., Crispini, L., Federico, L., Seno, S., & Maino, M. (2025). Quantitative characterization of fracture network in large sheath-fold: field and UAV-based digital outcrop model analysis (Ligurian Alps, Italy). Journal of Structural Geology, 201, 105551. https://doi.org/10.1016/j.jsg.2025.105551
Rasimeng, S., Fahruddin, F., Valentin, F., Aurora, T. G., & Nurlaili, J. (2024). Subsurface Interpretation of the Panjang Fault Area, Lampung, Based on Geomagnetic Method. Jurnal Geocelebes, 8(1), 37–50. https://doi.org/10.20956/geocelebes.v8i1.28303
Rossi, M., Olsson, P.-I., Johanson, S., Fiandaca, G., Bergdahl, D. P., & Dahlin, T. (2017). Mapping geological structures in bedrock via large‐scale direct current resistivity and time‐domain induced polarization tomography. Near Surface Geophysics, 15(6), 657–667. https://doi.org/10.3997/1873-0604.2017058
Sanderson, D. J., & Nixon, C. W. (2018). Topology, connectivity and percolation in fracture networks. Journal of Structural Geology, 115, 167–177. https://doi.org/10.1016/j.jsg.2018.07.011
Sarkowi, M., Damayanti, L., Rosadi, V. A., Pinandita, A. H., Fajriyanto, F., Hendrawan, R. N., Wibowo, A., & Wibowo, R. C. (2025). Fault Identification Using Inversion Modeling and Gradient Method of Gravity Data in Bandar Lampung City. IOP Conference Series: Earth and Environmental Science, 1517, 012016. https://doi.org/10.1088/1755-1315/1517/1/012016
Sulandari, B., Suteja, A., Hadibroto, H., Nurmaliah, N., Setyanta, B., & Garniwa, A. (2023). Deliniasi Struktur Sesar Lampung-Panjang dan Identifikasi Potensi Sumberdaya Alam Berdasarkan Anomali Magnet Daerah Bandar Lampung. Jurnal Geologi Dan Sumberdaya Mineral, 24(4), 195–203. https://doi.org/10.33332/jgsm.geologi.v24i4.721
Triantafyllou, A., Watlet, A., Le Mouélic, S., Camelbeeck, T., Civet, F., Kaufmann, O., Quinif, Y., & Vandycke, S. (2019). 3-D digital outcrop model for analysis of brittle deformation and lithological mapping (Lorette cave, Belgium). Journal of Structural Geology, 120, 55–66. https://doi.org/10.1016/j.jsg.2019.01.001
Watkins, H., Bond, C. E., Healy, D., & Butler, R. W. H. (2015). Appraisal of fracture sampling methods and a new workflow to characterise heterogeneous fracture networks at outcrop. Journal of Structural Geology, 72, 67–82. https://doi.org/10.1016/j.jsg.2015.02.001
Zeng, Q.-H., Wang, W.-Z., Ma, Z.-G., Shen, J., Shao, Y., Deng, F., & Wang, Q. (2025). Cavity and Fracture Extraction of CarbonateRocks Digital Outcrop Model. Proceedings of the International Field Exploration and Development Conference 2024, 209–219. https://doi.org/10.1007/978-981-96-2706-6_16
Unduhan
Diterbitkan
Terbitan
Bagian
Lisensi
Hak Cipta (c) 2026 JURNAL GEOCELEBES
Artikel ini berlisensiCreative Commons Attribution-NonCommercial-ShareAlike 4.0 International License.
Authors who publish with this journal agree to the following terms:
- Authors retain copyright and grant the journal right of first publication with the work simultaneously licensed under a Creative Commons Attribution License that allows others to share the work with an acknowledgement of the work's authorship and initial publication in this journal.
- Authors are able to enter into separate, additional contractual arrangements for the non-exclusive distribution of the journal's published version of the work (e.g., post it to an institutional repository or publish it in a book), with an acknowledgement of its initial publication in this journal.
- Authors are permitted and encouraged to post their work online (e.g., in institutional repositories or on their website) prior to and during the submission process, as it can lead to productive exchanges, as well as earlier and greater citation of published work (See The Effect of Open Access).
